MyDigitalSSD Bullet Proof Half Slim Solid State Drives (SSD) deliver all the advantages of Flash Disk technology with the Serial ATA II interface, fully compliant with standard half-slim SSD form factor. SATA Drives are replacing the older and slower (PATA) interface in embedded environments. The MyDigitalSSD Half Slim drive is based on a standard 7-pin interface for data segment and 15-pin for power segment, designed to operate at a maximum operating frequency of 150MHz with 30MHz external crystal. Its capacity could provide a wide range from 4GB to up to 128GB. Also it can reach maximum 240 MB/s read as well as 190 MB/s write high performance based on MLC flash (with 64MB DDR enabled and measured by CrystalDiskMark v3.0). The power consumption of Flash Disk is much lower than traditional Hard Drive.

Electrical/Physical Interface

• SATA interface
  - Support SATA 1.5Gbps and 3.0Gbps interface
• DDR1 IO
  - Support DDR1 I/O interface
• Flash IO
  - Support 1.8V and 3.3V voltage level
  - Support 1.8V for ONFI Flash
  - Support 3.3V for conventional Asynchronous Flash

Controller Features

• SATA Revision 2.6 compliant
• Compatible with SATA 1.5Gbps and 3Gbps interface
• Power management supported
• Support expanded register for SATA protocol 48 bits addressing mode
• Embedded BIST function of SATA PHY for low cost mass production

NAND Flash Interface

• Build-in hardware ECC circuit (48bit/2KB)
• Support all types of SLC and MLC Large Block 8KB/page NAND flash
• ONFI2.0 Interface support: 4 channels max
• Bus Width: 8/16 bit
• Support 1pc to 4pcs TSOP/ULGA Flash chip enable

DDR1 Interface

• 16 bit data bus
• Data Rate: 300Mbps
• Support Capacity : 64MB

Drive Features

• Build in 32 bits micro-controller
• UART
• GPIO

Note: Solid State Drives DO NOT require defragmentation. It may decrease the lifespan of the drive.

• MyDigitalSSD 32GB Bullet Proof Half Slim SATA II SSD Solid State Drive

• 3 Year Warranty