UltraBook, Tablet, and Hybrid HDD/mSATA owners rejoice!

The cost efficient high speed mSATA upgrade you've been looking for is here with the reliability you've come to expect from MyDigitalSSD Bullet Proof SSDs.

Introducing MyDigitalSSD Bullet Proof 3 (BP3) 50mm mSATA III solid state drives for Notebooks, Ultrabooks, Tablets, and Desktop computers. BP3 drives are easy to install SSD upgrades that eliminate the bottle-neck of stock hard drives (HDDs) and double the performance of SATA II SSDs with speed boosts that not only increase productivity but lower energy consumption, prolonging battery life.

Backwards compatible with SATA II applications, BP3 drives will peg SATA II BUS speeds in most cases.

About the Controller

MyDigitalSSD BP3 SSDs feature the Phison S-Module III S8 controller to deliver all the advantages of Flash Disk technology with the Serial ATA III interface, fully compliant with standard mSATA form factor. The S-Module III S8 is based on the mSATA form factor which is generated by JEDEC, designed to operate at a maximum operating frequency of 300MHz with 40MHz external crystal. Its capacity could provide a wide range up to 256GB. Also it can reach 500MB/s throughput based on ONFI/Toggle NAND (with DDR3 cache enabled and measured by CrystalDiskMark). Also the power consumption of mSATA module is much lower than traditional Hard Drive.

Highlights

• Unequaled price to performance ratio
• 24nm Toshiba Toggle-Mode NAND Flash
• Large storage capacity
• Easy remove and replace installation
• SATA Revision 3.0 compliant: High-speed SATA 6Gb/s interface
• Compatible with SATA 1.5G/s, 3Gb/s interface
• Support DDR3 I/O interface
• Power management supported
• NCQ command set
• TRIM support
• RAID support
• Three year replacement warranty

Features

• High and Reliable ECC capability up to 24bits/sector
• Bit error monitoring and management
• Dynamic and static wear-leveling
• Dynamic bad block management
• ONFI2.0 and Toggle2 Interface support
• Supports 1.8V and 3.3V voltage level
  - Supports 1.8V for ONFI Flash
  - Supports 3.3V for conventional Asynchronous Flash
• DDR3 Interface
  - 16 bit data bus
  - Clock Rate: 480MHz

Note: Solid State Drives DO NOT require defragmentation. It may decrease the lifespan of the drive.

Performance Testing

Test Environment: Lenovo Thinkpad X220 / Windows 7 Pro 64 -SP1 / Intel Core i5-2520M / QM67 Chipset / 4GB DDR3-1333 / MSAHCI Storage drivers / SATA 6G Tests performed in the 7MM Bay with the Renice mSATA to SATA II/6G adapter.

ATTO Benchmark After Firmware Update
Test Drive: 64GB MyDigital BP3 SSD

• 256GB MyDigitalSSD BP3 mSATA 6G SSD

• 3 Year Warranty